SPECIFICATIONS

Adjustable water flow: With controller for adjustable water flow

Brand Name: XMSJ

CP-25 maximum glass thickness: 12MM

CP-25 power: 25W

CP-40 maximum glass thickness: 15MM

CP-40 power: 40W

CP-55 maximum glass thickness: 19MM

CP-55 power: 55W

CP25 recommended to use aquarium: 0.6-1M

CP40 recommended to use aquarium: 1M-1.2M

CP50 recommended to use aquarium: 1.2M-1.5M

High-concerned chemical: none

Origin: Mainland China

Voltage: 110-240V

a fixed way: Magnet fixing

plug: We will give you a local plug

The wave-making pump is good at making waves and it is spectacular to watch. In fact, they can only push up and down a part of the water in the fish tank from the vertical direction. In the horizontal direction, the driving force is rather weak, especially near the bottom of the tank, and almost no water flow can occur. as the picture shows

Cross flow technology

1. Flow coverage is almost no dead ends

2. Slow flow rate through the cylinder

3. The flow of water rebounds from the cylinder wall at the other end to form a "circulation"

Traditional technology

1. There is more dead space in the flow of water

2. The water flow in the middle of the cylinder is too strong

3. The water flow at the other end of the cylinder is very weak

SPPED: Adjusting Traffic Size

FEED: feeding mode

H: Fixed flow mode

W1: Classical Flow Mode

W2: Positive Reversal Mode

W3: Fixed Program Flow Model

MODE: switch mode

Warning: The light indicates that the work is abnormal. Please restart after handling the fault.

P&N button: Set the direction of flow

LOCK: lock wave

After feeding mode

The submersible pump will stop working and the timer will be fed for ten minutes to allow the body of water to stand still for the fish to eat. Ten minutes later, the submersible pump will automatically start working.

Four flow modes

The four modes of operation can produce a uniform stream of water that will produce a flow of water throughout the tank and a variety of coral foraging will reach the highest

First deduct the buckle

Do not use excessive force to avoid breaking

Axis pushes out toward the opening

Remove the rotor and motor section

Check whether there is debris in the rotating leaves

Left and right side can remove the impeller